Common faults and troubleshooting methods of rubber mixer

The common faults and troubleshooting methods of rubber mixer are as follows:

The main reason for the sliding of the fixed and rotor shafts of the internal mixer is that there is no oil or iron blocks entering between the shafts and sleeves. Exclusion method: Add an appropriate amount of lubricating oil to the mixing chamber to make the shaft rotate flexibly in the sleeve, and remove the incoming iron block with pliers.

The gap between the upper and lower guide rings of the internal mixer and the machine body is too large, causing the material to not fall smoothly from the lower guide ring. Exclusion method: Adjust the gap between the guide rail ring and the body to maintain it within a reasonable range.

The materials in the mixing room of the internal mixer are slipping. Troubleshooting method: Adjust the rotor speed and increase the amount of material.

The main reason for the heating of the mixing chamber body of the internal mixer is that there is no lubricating oil or iron blocks entering between the rotor and the body. Exclusion method: Add an appropriate amount of lubricating oil to the mixing chamber body to make the rotor rotate flexibly in the body, and remove the incoming iron block with pliers.

The main reason for material slippage in the mixing room of the internal mixer is due to excessive rotor speed or insufficient material volume. Troubleshooting method: Adjust the rotor speed and increase the amount of material.

The main reason for the oscillation of the mixer body is that there is no oil between the shaft and the sleeve or iron blocks enter. Exclusion method: Add an appropriate amount of lubricating oil to the body to make the shaft rotate flexibly in the sleeve, and remove the iron block that enters with pliers.

The abnormal sound of the mixer body is mainly caused by the absence of oil between the shaft and sleeve or the entry of iron blocks. Exclusion method: Add an appropriate amount of lubricating oil to the body to make the shaft rotate flexibly in the sleeve, and remove the iron block that enters with pliers.

The main reason for the fracture of the internal mixer body shaft is that there is no oil or iron blocks entering between the shaft and the sleeve. Exclusion method: Add an appropriate amount of lubricating oil to the body to make the shaft rotate flexibly in the sleeve, and remove the iron block that enters with pliers.

The main reason for the bending and deformation of the shaft of the mixer body is that there is no oil or iron blocks entering between the shaft and the sleeve. Exclusion method: Add an appropriate amount of lubricating oil to the body to make the shaft rotate flexibly in the sleeve, and remove the iron block that enters with pliers.

The gap between the shaft and sleeve of the mixer body is too large, causing the material to not fall smoothly from the lower guide ring. Exclusion method: Adjust the gap between the guide rail ring and the body to maintain it within a reasonable range.

The above are common faults and troubleshooting methods for rubber mixers. If your rubber mixer encounters malfunctions and cannot be repaired during operation, please contact us, and our engineers will provide you with assistance.